Author Guidelines

The authors can register and prepare the manuscript following the instructions for authors given below before submitting it online. Basically, Jurnal Teknologi dan Informasi (JATI) (p-ISSN: 2088-2270, e-ISSN: 2655-6839) follows the author guidelines attached here (use that template). Manuscripts submitted for publication in JATI should be a minimum of 4,000 words (Introduction - Conclusion) and between 6 - 16 pages long when typed in single spacing including tables and figures. The abstract should be from 150 to 250 words.

Register

Registration and login are required to submit items online and to check the status of current submissions.

Already have a Username/Password for the Jurnal Teknologi dan Informasi (JATI)?
Go to Login

Need a Username/Password?
Go to Registration

Already logged in?
Start new submission

Preparation

Use of word processing software

It is important that the file be saved in the native format of the word processor used. The text should be in single-column format. Keep the layout of the text as simple as possible. Most formatting codes will be removed and replaced on processing the article. In particular, do not use the word processor's options to justify text or to hyphenate words. However, do use boldface, italics, subscripts, superscripts, etc. When preparing tables, if you are using a table grid, use only one grid for each individual table and not a grid for each row. If no grid is used, use tabs, not spaces, to align columns. The electronic text should be prepared in a way very similar to that of conventional manuscripts. Note that source files of figures, tables, and text graphics will be required whether or not you embed your figures in the text. See also the section on Electronic artwork. To avoid unnecessary errors you are strongly advised to use the 'spell-check' and 'grammar-check' functions of your word processor.

Article structure

  • Subdivision - numbered sections: Divide your article into clearly defined and numbered sections. Subsections should be numbered 3.1 (then 3.1.1, 3.1.2, ...), etc. (the abstract is not included in section numbering). Use this numbering also for internal cross-referencing: do not just refer to 'the text'. Any subsection may be given a brief heading. Each heading should appear on its own separate line.
  • Introduction: State the objectives of the work and provide an adequate background, avoiding a detailed literature survey or a summary of the results.
  • Material and methods: Provide sufficient detail to allow the work to be reproduced. Methods already published should be indicated by a reference: only relevant modifications should be described.
  • Results: Results should be clear and concise.
  • Discussion: This should explore the significance of the results of the work, not repeat them. A combined Results and Discussion section is often appropriate. Avoid extensive citations and discussion of published literature.
  • Conclusions: The main conclusions of the study may be presented in a short Conclusions section, which may stand alone or form a subsection of a Discussion or Results and Discussion section.

Essential title page information

  • Title: Concise and informative. Titles are often used in information retrieval systems. Avoid abbreviations and formulae where possible.
  • Author names and affiliations: Please clearly indicate the given name(s) and family name(s) of each author and check that all names are accurately spelt. Present the authors' affiliation addresses (where the actual work was done) below the names. Indicate all affiliations with a lower-case superscript letter immediately after the author's name and in front of the appropriate address. Provide the full postal address of each affiliation, including the country name and, if available, the e-mail address of each author.
  • Corresponding author. Clearly indicate who will handle correspondence at all stages of refereeing and publication, as well as post-publication. Ensure that the e-mail address is given and that contact details are kept up to date by the corresponding author.
  • Present/permanent address. If an author has moved since the work described in the article was done, or was visiting at the time, a 'Present address' (or 'Permanent address') may be indicated as a footnote to that author's name. The address at which the author actually did the work must be retained as the main, affiliation address. Superscript Arabic numerals are used for such footnotes.

Abstract

A concise and factual abstract is required. The abstract should state briefly the purpose of the research, the principal results, and major conclusions. An abstract is often presented separately from the article, so it must be able to stand alone. For this reason, References should be avoided, but if essential, then cite the author(s) and year(s). Also, non-standard or uncommon abbreviations should be avoided, but if essential they must be defined at their first mention in the abstract itself.

Graphical abstract

Although a graphical abstract is optional, its use is encouraged as it draws more attention to the online article. The graphical abstract should summarize the contents of the article in a concise, pictorial form designed to capture the attention of a wide readership. Graphical abstracts should be submitted as a separate file in the online submission system. Image size: Please provide an image with a minimum of 531-1328 pixels or proportionally more. The image should be readable at a size of 5-13 cm using a regular screen resolution of 96 dpi. Preferred file types: TIFF, EPS, PDF or MS Office files. 

Keywords

Immediately after the abstract, provide 3 - 5 keywords, using American spelling and avoiding general and plural terms and multiple concepts (avoid, for example, 'and', 'of'). Be sparing with abbreviations: only abbreviations firmly established in the field may be eligible. These keywords will be used for indexing purposes. Acknowledgments Collate acknowledgements in a separate section at the end of the article before the references and do not, therefore, include them on the title page, as a footnote to the title or otherwise. List here those individuals who provided help during the research (e.g., providing language help, writing assistance or proofreading the article, etc.).

Math formulae

Please submit math equations as editable text and not as images. Present simple formulae in line with normal text where possible and use the solidus (/) instead of a horizontal line for small fractional terms, e.g., X/Y. In principle, variables are to be presented in italics. Powers of e are often more conveniently denoted by exp. Number consecutively any equations that have to be displayed separately from the text (if referred to explicitly in the text).

Tables

Please submit tables as editable text and not as images. Tables can be placed either next to the relevant text in the article, or on separate page(s) at the end. Number tables consecutively in accordance with their appearance in the text and place any table notes below the table body. Be sparing in the use of tables and ensure that the data presented in them do not duplicate results described elsewhere in the article. Please avoid using vertical rules.

References

Citation in text

Please ensure that every reference cited in the text is also present in the reference list (and vice versa). Any references cited in the abstract must be given in full. Unpublished results and personal communications are not recommended in the reference list but may be mentioned in the text. If these references are included in the reference list they should follow the standard reference style of the journal and should include a substitution of the publication date with either 'Unpublished results' or 'Personal communication'. Citation of a reference as 'in press' implies that the item has been accepted for publication.

Web references

As a minimum, the full URL should be given and the date when the reference was last accessed. Any further information, if known (DOI, author names, dates, reference to a source publication, etc.), should also be given. Web references can be listed separately (e.g., after the reference list) under a different heading if desired, or can be included in the reference list.

Reference management software

Using the word processor plug-ins from these products, authors only need to select the appropriate journal template when preparing their article, after which citations and bibliographies will be automatically formatted in the journal's style. If no template is yet available for this journal, please follow the format of the sample references and citations as shown in this Guide. Users of Mendeley Desktop can easily install the reference style for this journal. When preparing your manuscript, you will then be able to select this style using the Mendeley plugins for Microsoft Word.

Reference style

Text: Citations in the text should follow the referencing style used by The Institute for Electrical and Electronics Engineers (IEEE). IEEE citation style includes in-text citations, numbered in square brackets, which refer to the full citation listed in the reference list at the end of the paper. The reference list is organized numerically, not alphabetically. For example, see the IEEE Editorial Style Manual.  Basically, it is not necessary to mention an author's name, pages used or date of publication in the in-text citation. Instead, refer to the source with a number in a square bracket, e.g. [1], that will then correspond to the full citation in your reference list.

  • Place bracketed citations within the line of text, before any punctuation, with space before the first bracket.
  • Number your sources as you cite them in the paper. Once you have referred to a source and given it a number, continue to use that number as you cite that source throughout the paper.
  • When citing multiple sources at once, the preferred method is to list each number separately, in its own brackets, using a comma or dash between numbers, as such: [1], [2, 3], [4] [5], or [1] - [5].

Examples:
Book in print:
[1] B. Klaus and P. Horn, Robot Vision. Cambridge, MA: MIT Press, 1986.

Chapter in the book:
[2] L. Stein, Random patterns in Computers and You, J. S. Brake, Ed. New York: Wiley, 1994, pp. 55-70.

eBook:
[3] L. Bass, P. Clements, and R. Kazman, Software Architecture in Practice, 2nd ed. Reading, MA: Addison Wesley, 2003. [E-book] Available: Safari e-book.

Journal article:
[4] J. U. Duncombe, "Infrared navigation - Part I: An assessment of feasibility," IEEE Trans. Electron. Devices, vol. ED-11, pp. 34-39, Jan. 1959.

eJournal (from database):
[5] H. K. Edwards and V. Sridhar, "Analysis of software requirements engineering exercises in a global virtual team setup," Journal of Global Information Management, vol. 13, no. 2, p. 21+, April-June 2005. [Online]. Available: Academic OneFile, http://find.galegroup.com.

eJournal (from the internet):
[6] A. Altun, "Understanding hypertext in the context of reading on the web: Language learners' experience," Current Issues in Education, vol. 6, no. 12, July 2003. [Online]. Available: http://cie.ed.asu.edu/volume6/number12/.

Conference paper:
[7] L. Liu and H. Miao, "A specification-based approach to testing polymorphic attributes," in Formal Methods and Software Engineering: Proceedings of the 6th International Conference on Formal Engineering Methods, ICFEM 2004, Seattle, WA, USA, November 8-12, 2004, J. Davies, W. Schulte, M. Barnett, Eds. Berlin: Springer, 2004. pp. 306-19.

Conference proceedings:
[8] T. J. van Weert and R. K. Munro, Eds., Informatics and the Digital Society: Social, ethical and cognitive issues: IFIP TC3/WG3.1&3.2 Open Conference on Social, Ethical and Cognitive Issues of Informatics and ICT, July 22-26, 2002, Dortmund, Germany. Boston: Kluwer Academic, 2003.

Newspaper article (from database):
[9] J. Riley, "Call for a new look at skilled migrants," The Australian, p. 35, May 31, 2005. [Online]. Available: Factiva, http://global.factiva.com.

Technical report:
[10] J. H. Davis and J. R. Cogdell, “Calibration program for the 16-foot antenna,” Elect. Eng. Res. Lab., Univ. Texas, Austin, Tech. Memo. NGL-006-69-3, Nov. 15, 1987.

Patent:
[11] J. P. Wilkinson, Nonlinear resonant circuit devices, U.S. Patent 3 624 125, July 16, 1990.

Standard:
[12] IEEE Criteria for Class IE Electric Systems, IEEE Standard 308, 1969.

Thesis/Dissertation:
[13] J. O. Williams, Narrow-band analyzer, PhD dissertation, Dept. Elect. Eng., Harvard Univ., Cambridge, MA, 1993.